SPBT2532C2AT datasheet(36/48 Pages) STMICROELECTRONICS

36 / 48 page

Commands

SPBT2532C2.AT

36/48

Doc ID 16089 Rev 3

C.28

Sniff

The Sniff command is used to switch a device from active mode to sniff mode.

C.28.1

Syntax

AT+AB Sniff [BD address] [Sniff Interval]

Where

[BD address] is the BD address of the device to be switched to active mode.

[Sniff Interval] is given in slots from 66-10,000.

C.28.2

Responses

If the operation is successful, the response is:

AT-AB SniffMode

C.29

SPPConnect

The SPPConnect command is used to initiate a connection with the specified device. The

remote BD address must be specified. The remote Service is optional. If not specified, the

first registered SPP service will be used by default.

C.29.1

Syntax

AT+AB SPPConnect [BD Addr] [Service]

Where

[BD Addr] is the remote devices BD Address to page. [Service] is the specific

service on the remote device; optional.

C.29.2

Responses

If the connection is successful, the response is:

AT-AB ConnectionUp

AT-AB -BypassMode-

If the connection cannot be completed, the response is:

AT-AB SPPConnectionClosed

C.30

SPPDisconnect

The SPPDisconnect command is used to terminate a connection with the remote device.

C.30.1

Syntax

AT+AB SPPDisconnect

C.30.2

Responses

If the connection is successful, the response is

AT-AB SPPConnectionClosed

SPBT2532C2AT データシート(PDF) 36 Page - STMicroelectronics

SPBT2532C2AT データシート(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

データシートダウンロード

リンク URL

SPBT2532C2AT データシート(PDF) 36 Page - STMicroelectronics

SPBT2532C2AT データシート(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

データシート ダウンロード

リンク URL

データシートダウンロード