WM8753LEBSLASHV datasheet(71/87 Pages) WOLFSON

71 / 87 page

WM8753L

Advanced Information

AI Rev 3.1 June 2004

POWER MANAGEMENT

The WM8753L has three control registers that allow users to select which functions are active. For

minimum power consumption, unused functions should be disabled. To avoid any pop or click noise,

it is important to enable or disable functions in the correct order (see Applications Information).

VMIDSEL is the enable for the Vmid reference, which defaults to disabled and can be enabled as a

50k

Ω potential divider or, for low power maintenance of Vref when all other blocks are disabled, as a

500k

Ω potential divider.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

8:7

VMIDSEL

Vmid divider enable and select

00 – Vmid disabled (for OFF mode)

01 – 50k

Ω divider enabled (for

playback/record)

10 – 500k

Ω divider enabled (for low-power

standby)

11 – 5k

Ω divider enabled (for fast start-up)

VREF

enable

(necessary

for

all

other

functions)

MICB

MIC Bias enable

VDAC

Voice DAC enable

DACL

DAC Left enable

DACR

DAC Right enable

R20 (14h)

Power

Management

(1)

DIGENB

Disables MCLK into digital

MICAMP1EN

Mic1 preamp enable

MICAMP2EN

Mic2 preamp enable

ALCMIX

ALC mixer enable

PGAL

ADC left PGA enable

PGAR

ADC right PGA enable

ADCL

Left ADC enable

ADCR

Right ADCR enable

RXMIX

RX mixer enable

R21 (15h)

Power

Management

(2)

LINEMIX

Line mixer enable

LOUT1

LOUT1 enable

ROUT1

ROUT1 enable

LOUT2

LOUT2 enable

ROUT2

ROUT2 enable

OUT3

OUT3 enable

OUT4

OUT4 enable

MONO1

MONO1 enable

R22 (16h)

Power

Management

(3)

MONO2

MONO2 enable

RECMIX

Record Mixer Enable

MONOMIX

Mono mixer enable

RIGHTMIX

Right mixer enable

R23 (17h)

Power

Management

(4)

LEFTMIX

Left mixer enable

Note: All control bits are 0=OFF, 1=ON

Table 69 Power Management

SAVING POWER AT LOW SUPPLY VOLTAGES

The analogue supplies to the WM8753L can run from 1.8V to 3.6V. By default, all analogue circuitry

on the device is optimized to run at 3.3V. This set-up is also good for all other supply voltages down

to 1.8V. However, at lower voltages, it is possible to save power by reducing the internal bias currents

used in the analogue circuitry. This is controlled as shown below.

WM8753LEB/V データシート(PDF) 71 Page - Wolfson Microelectronics plc

WM8753LEB/V データシート(HTML) 71 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

データシートダウンロード

リンク URL

WM8753LEB/V データシート(PDF) 71 Page - Wolfson Microelectronics plc

WM8753LEB/V データシート(HTML) 71 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

データシート ダウンロード

リンク URL

データシートダウンロード