| データシートサーチシステム |
|
SH7041A データシート(PDF) 468 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
SH7041A データシート(HTML) 468 Page - Renesas Technology Corp |
|
468 / 923 page ![]() 430 (17) Operation when Error Occurs during Phase Counting Mode Operation, and Operation is Restarted in Normal Mode: Figure 12.112 shows an explanatory diagram of the case where an error occurs in phase counting mode and operation is restarted in normal mode after re-setting. 1 RESET 2 TMDR (PCM) 3 TIOR (1 init 0 out) 5 TSTR (1) 4 PFC (MTU) 6 Match 7 Error occurs 8 PFC (PORT) 9 TSTR (0) 10 TMDR (normal) 11 TIOR (1 init 0 out) 12 PFC (MTU) 13 TSTR (1) MTU output TIOC*A TIOC*B Port output PEn PEn n=0 to 15 High-Z High-Z Figure 12.112 Error Occurrence in Phase Counting Mode, Recovery in Normal Mode 1.After a reset, MTU output is low and ports are in the high-impedance state. 2.Set phase counting mode. 3. Initialize the pins with TIOR. (The example shows initial high output, with low output on compare-match occurrence.) 4.Set MTU output with the PFC. 5.The count operation is started by TSTR. 6.Output goes low on compare-match occurrence. 7.An error occurs. 8.Set port output with the PFC and output the inverse of the active level. 9.The count operation is stopped by TSTR. 10.Set in normal mode. 11.Initialize the pins with TIOR. 12.Set MTU output with the PFC. 13.Operation is restarted by TSTR. |
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか? [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |