TAS5731MPHPR datasheet(39/68 Pages) TI1

39 / 68 page

AVDD/DVDD

PDN

PVDD

RESET

T0420-05

I C

2ms

0ns

TAS5731M

www.ti.com

SLOS838B – JULY 2013 – REVISED NOVEMBER 2013

Figure 66. Power-Loss Sequence

Initialization Sequence

Use the following sequence to power up and initialize the device:

Hold all digital inputs low and ramp up AVDD/DVDD to at least 3 V.

Initialize digital inputs and PVDD supply as follows:

•

Drive RESET = 0, PDN = 1, and other digital inputs to their desired state while ensuring that

all are never more than 2.5 V above AVDD/DVDD. Wait at least 100 µs, drive RESET = 1,

and wait at least another 13.5 ms.

•

Ramp up PVDD to at least 8 V while ensuring that it remains below 6 V for at least 100 µs

after AVDD/DVDD reaches 3 V. Then wait at least another 10 µs.

Trim oscillator (write 0x00 to register 0x1B) and wait at least 50 ms.

Configure the DAP via I2C (see User's Guide for typical values).

Configure remaining registers.

Exit shutdown (sequence defined below).

Normal Operation

The following are the only events supported during normal operation:

Writes to master/channel volume registers

Writes to soft-mute register

Enter and exit shutdown (sequence defined below)

Note: Event 3 is not supported for 240 ms + 1.3 × tstart after trim following AVDD/DVDD power-up ramp

(where tstart is specified by register 0x1A).

Product Folder Links :TAS5731M

TAS5731MPHPR データシート(PDF) 39 Page - Texas Instruments

TAS5731MPHPR データシート(HTML) 39 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

データシートダウンロード