PARAMETER DEFINITIONS

Linearity Error

The deviation of a code from a straight line passing through the endpoints of the transfer

function after zero- and full-scale errors have been accounted for. "Zero-scale" is a point 1/2 LSB

below the first code transition and "full-scale" is a point 1/2 LSB beyond the code transition to

all ones. The deviation is measured from the middle of each particular code. Units in %

Full-Scale.

Differential Linearity

Minimum resolution for which no missing codes is guaranteed. Units in bits.

Full Scale Error

The deviation of the last code transition from the ideal (VREF-3/2 LSB’s).

Units in LSB’s.

Unipolar Offset

The deviation of the first code transition from the ideal (1/2 LSB above AGND) when in

unipolar mode (BP/UP low). Units in LSB’s.

Bipolar Offset

The deviation of the mid-scale transition (011...111 to 100...000) from the ideal (1/2 LSB below

AGND) when in bipolar mode (BP/UP high). Units in LSB’s.

Bipolar Negative Full-Scale Error

The deviation of the first code transition from the ideal when in bipolar mode (BP/UP high). The

ideal is defined as lying on a straight line which passes through the final and mid-scale code

transitions. Units in LSB’s.

Peak Harmonic or Spurious Noise (More accurately, Signal to Peak Harmonic or Spurious Noise)

The ratio of the rms value of the signal to the rms value of the next largest spectral component

below the Nyquist rate (excepting dc). This component is often an aliased harmonic when the

signal frequency is a significant proportion of the sampling rate. Expressed in decibels.

Total Harmonic Distortion

The ratio of the rms sum of all harmonics to the rms value of the signal. Units in percent.

Signal-to-Noise Ratio

The ratio of the rms value of the signal to the rms sum of all other spectral components below

the Nyquist rate (excepting dc), including distortion components. Expressed in decibels.

Aperture Time

The time required after the hold command for the sampling switch to open fully. Effectively a

sampling delay which can be nulled by advancing the sampling signal. Units in nanoseconds.

Aperture Jitter

The range of variation in the aperture time. Effectively the "sampling window" which ultimately

dictates the maximum input signal slew rate acceptable for a given accuracy. Units in

picoseconds.

NOTE: Temperatures specified define ambient conditions in free-air during test and do not refer to the junction

temperature of the device.

CS5012A, CS5014, CS5016

2-44

DS14F8

CS5012A CS5014 CS5016

DS14F9

37