WM9090ECSSLASHR datasheet(78/81 Pages) WOLFSON

78 / 81 page

WM9090

Production Data

PD, November 2010, Rev 4.1

A simple equivalent circuit of a loudspeaker consists of a serially connected resistor and inductor, as

shown in Figure 20. This circuit provides a low pass filter for the speaker output. If the loudspeaker

characteristics are suitable, then the loudspeaker itself can be used in place of the filter components

described earlier. This is known as ‘filterless’ operation.

Figure 20 Speaker Equivalent Circuit for Filterless Operation

For filterless Class D operation, it is important to ensure that a speaker with suitable inductance is

chosen. For example, if we know the speaker impedance is 8Ω and the desired cut-off frequency is

20kHz, then the optimum speaker inductance may be calculated as:

Ω loudspeakers typically have an inductance in the range 20μH to 100μH, however, it should be

noted that a loudspeaker inductance will not be constant across the relevant frequencies for Class D

operation (up to and beyond the Class D switching frequency). Care should be taken to ensure that

the cut-off frequency of the loudspeaker’s filtering is low enough to suppress the high frequency

energy of the Class D switching and, in so doing, to prevent speaker damage. The Class D outputs

of the WM9090 operate at much higher frequencies than is recommended for most speakers and it

must be ensured that the cut-off frequency is low enough to protect the speaker.

WM9090ECS/R データシート(PDF) 78 Page - Wolfson Microelectronics plc