ADXL346

Data Sheet

Parameter

Test Conditions

Min1

Typ2

Max1

Unit

TEMPERATURE

Operating Temperature Range

−40

+85

°C

WEIGHT

Device Weight

18

mg

1

All minimum and maximum specifications are guaranteed. Typical specifications are not guaranteed.

2

The typical specifications shown are for at least 68% of the population of parts and are based on the worst case of mean ±1 σ except for 0 g output and sensitivity,

which represents the target value. For 0 g offset and sensitivity, the deviation from the ideal describes the worst case of mean ±1 σ.

3

Cross-axis sensitivity is defined as coupling between any two axes.

4

Bandwidth is the −3 dB frequency and is half the output data rate bandwidth = ODR/2.

5

The output format for the 3200 Hz and 1600 Hz ODRs is different from the output format for the remaining ODRs. This difference is described in the Data Formatting of

Upper Data Rates section.

6

Output data rates below 6.25 Hz exhibit additional offset shift with increased temperature, depending on selected output data rate. Refer to the Offset Performance at

Lowest Data Rates section for details.

7

These are typical values for the lowest and highest output data rate settings.

8

Self-test change is defined as the output (g) when the SELF_TEST bit = 1 (in the DATA_FORMAT register, Address 0x31) minus the output (g) when the SELF_TEST bit = 0.

Due to device filtering, the output reaches its final value after 4 × τ when enabling or disabling self-test, where τ = 1/(data rate). The part must be in normal power

operation (LOW_POWER bit = 0 in the BW_RATE register, Address 0x2C) for self-test to operate correctly.

9

Turn-on and wake-up times are determined by the user-defined bandwidth. At a 100 Hz data rate, the turn-on and wake-up times are each approximately 11.1 ms. For

other data rates, the turn-on and wake-up times are each approximately τ + 1.1 in milliseconds, where τ = 1/(data rate).

Rev. C | Page 4 of 40