L9803 datasheet(20/126 Pages) STMICROELECTRONICS

部品番号	L9803

部品情報	Super smart power motor driver with 8-Bit MCU, RAM, EEPROM, ADC, WDG, Timers, PWM and H-bridge driver

PDF	126 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

20 / 126 page

Clocks, Reset, Interrupts & Power saving modes

L9803

20/126

Figure 8.

Timing Diagram for Internal CPU Clock Frequency transitions

3.2

Oscillator safeguard

The L9803 contains an oscillator safe guard function.

This function provides a real time check of the crystal oscillator generating a reset condition

when the clock frequency has anomalous value.

If fOSC<flow, a reset is generated.

If fOSC>fhigh, a reset is generated.

A flag in the Dedicated Control Status Register indicates if the last reset is a safeguard

reset.

At the output of reset state the safeguard is disable. To activate the safeguard SFGEN bit

must be set.

Note:

Following a reset, the safeguard is disabled. Once activated it cannot be disabled, except by

a reset.

3.2.1

Dedicated Control Status Register

DCSR

Address 0022h - Read/Write

Reset Value:xx00 0000 (00h)

b6 = SGFH: Safeguard high flag. Set by an Oscillator Safeguard Reset generated for

frequency too high, cleared by software (writing zero) or Power On / Low Voltage Reset.

b1 : b2

MISCELLANEOUS REGISTER

OSC/2

OSC/4

OSC/8

CPU CLK

VR02062B

New frequency

requested

New frequency

active when

osc/4 & osc/8 = 0

Normal mode active

(osc/4 - osc/8 stopped)

Normal mode

requested

SGFL

SGFH

SFGEN

CANDS

PIEN

L9803 データシート(PDF) 20 Page - STMicroelectronics

L9803 データシート(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード